Air shower room nine maintenance process

1. Regularly use the instrument to measure the technical indicators of the equipment. If it does not meet the requirements of the technical parameters, it should be dealt with in time.

2. According to the actual use, the filter material in the primary air filter should be removed and cleaned regularly.

3. When it is found that the wind speed changes, it should first check whether the surface of the primary air filter is black. If it is black, it means that the pre-filter contains more dust and the resistance increases, that is, the non-woven fabric in the primary air filter should be removed for cleaning or replacement.

4, when the replacement or cleaning of non-woven fabric, still can not improve the speed of the high efficiency air filter has been blocked, resulting in increased resistance, you should replace the high efficiency air filter.

5. When replacing the high efficiency filter, it is necessary to remove the spray ball plate, take out the high efficiency filter, and replace the new high efficiency air filter according to the specifications and models of the original high efficiency filter. During installation, the arrow mark on the hePA filter should be confirmed. The arrow should point to the direction of the air flow. And ensure that the seal is good to prevent leakage.
6. After the replacement of the high efficiency filter, it is necessary to confirm that the frame has no leakage phenomenon, and detect the dust particle counter. It can work normally after reaching the technical indicators.

7, regular maintenance of the electrical line, if there is a fault can refer to the electrical schematic for maintenance.

8. Enclose the door regularly to align the electronic lock with its keyhole so as not to lock the pin.

9. The use temperature shall not exceed 50℃, and the use of open flame is strictly prohibited.